Compool to EasyTouch Upgrade Manual Rev B 03-15-2010 - Pentair

30Using the Egg Timer (countdown) FeatureThe “Egg Timer” feature allows you switch off a circuit automatically after a specified time. The time periodis from one minute to 24 hours or run continuously. The “Egg Timer” (countdown) feature is useful forswitching off lighting and spa therapy jets. For example, a jet pump can be setup to switch off in 15 minutes,even if you switch it on using the iS4 or iS10 Spa-Side remote control or whenever you switch your spa on,you would like it to automatically switch it off in two hours. All Egg Timer programs are factory set to switchoff after 12 hours. You also have the option to use the “Don’t Stop” feature to run a circuit continuously untilmanually switched off.In the event of a power failure, the “Egg Timer” feature will not switch the circuit back on. Use the “Service”mode to turn the equipment back on. Refer to “Mode button,” page 4 for more information. For running thefilter pump continuously during new pool start up, it is recommended to use the “Service” mode, which willautomatically restart the filter pump in the event of a power failure.The following example describes how use the “Once Only” feature to program the spa circuit to switch thefilter pump on and rotate the valves into the “Spa” position and switch the heater on for one time only. Thisexample can also be used if you wanted to program when to filter and heat your pool, and switch light orauxiliary circuits on.To set the Egg Timer feature:Getting ThereMENU ▼ SCHEDULESSPA SPA 0 POOL 0AUX 1 0AUX 2 0 SPA 0/0 Mode: None (New)▲SPA 1/1Mode: Egg TimerTime: 05:00Right button: Select the Spa circuit. The generic circuit names are: Spa, Pool,Aux 1-7, Feature Circuit 1-8 and Aux Extra. Aux Extra is only available if the Solaroutput (J17) plug on the EasyTouch motherboard is not being used for solarequipment. Use the Solar button to switch the “extra” auxiliary circuit on and off (seepage 5).Right button: Select Mode if there are existing programs. Skip this step to create anew program.Up/Down button: Select New to create a new program.Right button: To create a new program and enter the “Mode” settings.Up/Down button: 1/1 indicates that this circuit has one program. If there are existingprograms assigned to this circuit, use these buttons to view and select the existingprogram settings.Right button: To select the “Egg Timer” settings.Right button: Select the time settings.Up/Down and Right buttons: Set the hour and minutes for the program to run. Thecount down time can be set from 00:01 to 23:59 and Don’t Stop. The “Don’t Stop”feature allows the circuit to run continuously until manually switched off.Press the Menu button to save the settings and to return to the Schedules menuoptions. Press the button again to return to the main menu options or press again toreturn to the main screen.Compool/EasyTouch Pool and Spa Control System Upgrade Installation and User’s Guide