Compool to EasyTouch Upgrade Manual Rev B 03-15-2010 - Pentair

22Setting up lights (Continued)ConfigFrom the “Config” screen you can setup the IntelliBrite light position, and specify the color of each pool andspa light. Any combination of up to eight IntelliBrite lights, Pentair SAM, SAL and or Fiberworks lights can bepreset for specific colors and position when using the “Color Swim” and “Color Set” feature. Fixed light colorare selected and activated from the Colors screen. Note: The “Config” menu settings do not apply to theMagicStream laminars.To select configure a light position and color: Menu > Lights > Config:1- [POOL ] 2- [SPA ]3- [BACK YARD ]4- [AUX 4auxiliary circuits.] 5- [NONE ] 6- [NONE ]7- [NONE ]8- [NONE ] [ AUX 4 ][ LAVENDER ][ 1ST POSITION ][ DELAY 5 SECS ]Up/Down buttons: Choose the light circuit (1-8) to configure. Select an availableauxiliary circuit (NONE). For more about assigning an auxiliary circuit to a light,see “Circuit Functions (page 39) and “Circuit Names” (page 37). Up to eight (8)Right button: Select the light to setup.Up/Down buttons: Select the light circuit.Right button: Select the light color selection.Up/Down buttons: Select the light color (Blue, Cyan, Green, Lt. Green,White, Lt. Magenta, Magenta, Lavender).Right button: Select the light position selection.Up/Down buttons: Select the light position. A light can be assigned to anyposition from 1 through 12. To ensure that the “Color Swim” and “Color Set”lighting feature color effects are correct, set the position of the light according towhere it’s located in the pool or spa. Position 1 will lead all the other lights in thecolor changing sequence. Position 2 follows Position 1 and so on. There are 12position to choose from. More than one light may be assigned to the same positionnumber so that their colors may be synchronized. For example, to make the colorsswim right to left, make your right most light Position 1. You may need to goback to and scroll through your lights to find the right most light, and set it asPosition 1.Right button: Select the light delay selection. The Delay time between two ormore lights can be set from 0 to 60 seconds. Use a higher delay time for lightsspread further apart. Try five seconds for all lights and observe the effect. Usedifferent time settings to achieve unique lighting moods and effects.Setting up SAM, SAL, PG2000, Color Wheel LightsPress the Menu button to setup other lights or press Menu button four timesto return main screen.Before using the lighting feature “Color Swim” or “Color Set” with Pentair SAM or SAL lights, make sure theAUX relay circuits which control the lights have been assigned as “light” circuit and that the name (AUX 1,AUX 2) has been changed to best fit the light being used. Verify that SAm and/or SAL, and/or FIBERworkshave been assigned in “Circuit Functions” as SAM or SAL light. If FIBERworks lighting is incorporated, italso has to be set up as a “PHOTON GENERATOR” light for the circuit controlling the light bulb, andCOLOR WHEEL for the circuit controlling the color wheel it self. The circuit light “functions” are: Light,SAM, SAL, Photon Generator, Color Wheel, and IntelliBrite, see page 40 for a more information.Compool/EasyTouch Pool and Spa Control System Upgrade Installation and User’s Guide