Compool to EasyTouch Upgrade Manual Rev B 03-15-2010 - Pentair

20Setting up lightsFrom the Lights screen you can manually switch all lights on or off, synchronize colored lights, and activatecolor light shows. Up to eight light circuits can be configured from the “Config” light menu. Each light musthave its own relay and separate circuit.Setting up IntelliBrite Light CircuitsBefore configuring the lights, be sure the auxiliary (AUX) circuits that control the IntelliBrite lights have beenassigned as an “IntelliBrite” light. For more information about “Circuit Functions” (page 39) and “CircuitNames,” (page 37).Lights MenuTo access the Lights menu screen, press Menu > Lights. The Lights menu settings are: MODES, COLORS,ALL ON, ALL OFF, SYNC, MAGICSTREAM, CONFIG:Getting There▲MENU LIGHTS LIGHTS▲Modes (IntelliBrite Color light shows, Color Swim, Color Set)To access the Modes menu, press Menu > Lights > Modes. There are six pre-programmed color lightshows to choose from. From the “Modes” screen you can select various preset show color lighting effects,such as “American mode” and “Sunset mode”, “Color Swim” or “Color Set.” Using the “Hold” and “Recall”feature (see page 21) you can also capture and save a unique color light show effect to recall at a later time.The IntelliBrite color “Mode” settings light shows are:• Party: Rapid color changing building the energy and excitement• Romance: Slow color transitions creating a mesmerizing and calming effect• Caribbean: Transitions between a variety of blues and greens• American: Patriotic red, white and blue transition• Sunset: Dramatic transitions of orange, red and magenta tones• Royalty: Richer, deeper, color tonesIntelliBrite Light: If the IntelliBrite light was not previously on, after selecting a color show mode, noillumination will occur for up to ten (10) seconds (depending on the selection), then a white light willmomentarily illuminate, followed by the color show mode selection. If the light was previously on,selecting the a color show mode button will momentarily illuminate the previously selected color beforechanging to the selected color show.Modes (Color Swim)The Color Swim feature cycles through white, magenta, blue and green colors. Using IntelliBrite lights, ColorSwim emulates the Pentair Water Pool and Spa SAM and SAL Color Swim feature.IntelliBrite Light Color Swim/Color Set: If the light was not previously on, after selecting Color Swim,no illumination will occur for approximately six (6) seconds followed by the selection. If the light waspreviously on, after selecting the Color Swim feature, the previously selected color will momentarilyilluminate, no illumination will occur for approximately six (6) seconds followed by the selection.Compool/EasyTouch Pool and Spa Control System Upgrade Installation and User’s Guide