Manual - Unvented Gas Log Heater or Vented Decorative Appliance

INSTALLATION REQUIREMENTSHeat ResistantMaterial10” or Less12”Min.28”DEB Unvented Gas LogsThe gas log heater must be installed at least 5" above anycombustible flooring material, such as carpeting or tile,which is closer than 14" to the base of the fireplace. Theminimum distance must be maintained from the top surfaceof carpeting, tile, etc. Figure 11OR,The gas log heater may be installed nearer to the floor if aminimum of 14" of noncombustible material such as slateor marble is installed between the base of the fireplace andthe combustible flooring. Figure 12Fp2799mantel no hood 24Heater in Fireplaceor FireboxFP2799Example: Thebottom of themantel may projectfrom the wall amaximum of 10" ata minimum of 28"above the opening.Figure 9 -DEB24/30 Minimum Mantel Clearance with No HoodMantel7”6”FP2876Heater inFireplace orFirebox5” MinimumFP2876combustible floorCombustibleMaterialFigure 11 -Minimum Clearance above Combustible FlooringMinimum of 8”Heat ResistantMaterial2”4”8”14”This DistanceMay Now beLess than 5”Heater inFireplace orFirebox14” MinimumCombustibleMaterialFP2800HoodFigure 10 -DEB24/30 Example of Unsafe FP2800 Installation - MinimumMantel Clearance with bad No mantel HoodFigure 10 is an example of an unsafe mantel installation.This mantel projects 4" at 8" above the opening,exceeding the maximum acceptable distance of 2Z\x" Themantel also projects 7" at 14Z\x" above the opening, exceedingthe maximum acceptable distance of 6".If your mantel profile is unsafe, you may either:• Raise the mantel to an acceptable heightor• Remove the mantelFigure 12 -Minimum Clearance above Combustible Floor with NoncombustibleMaterial Installed at Base of FireplaceFP2802non combustible floor44D0060 11