Manual - Unvented Gas Log Heater or Vented Decorative Appliance
Manual - Unvented Gas Log Heater or Vented Decorative Appliance
Manual - Unvented Gas Log Heater or Vented Decorative Appliance
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
OPERATING INSTRUCTIONS and CLEANING DEB <strong>Unvented</strong> & SERVICING <strong>Gas</strong> <strong>Log</strong>sMATCH lighting instructions1. Remove any items necessary f<strong>or</strong> easy access to the pilot (f<strong>or</strong> example: logs, screens, etc.).2. Follow appropriate lighting instructions found previously. Instead of pushing and releasing the piezobutton, light a match and hold the flame to the end of the pilot and ignite the pilot.3. After control knob has been released and pilot stays lit, reinstall any items that were removed f<strong>or</strong> pilotaccess.4. Call a qualified service technician f<strong>or</strong> repair <strong>or</strong> replacement of the piezo ignit<strong>or</strong>.WARNINGTurn off heater and allow to cool bef<strong>or</strong>ecleaning. Disconnect electrical powerbef<strong>or</strong>e cleaning <strong>or</strong> servicing.CLEANING AND SERVICINGAnnual inspection and cleaning by your dealer <strong>or</strong> qualified service technician is recommendedto prevent malfunction and/<strong>or</strong> sooting.Remove logs, handling carefully by holding gently at each end. Gloves are recommended to preventskin irritation from ceramic fibers. If skin becomes irritated, wash gently with soap and water. Referto manual f<strong>or</strong> c<strong>or</strong>rect log placement.Periodic Cleaning - Refer to parts diagram f<strong>or</strong> location of items discussed below.• Do not use cleaning fluid to clean logs <strong>or</strong> any part of heater.• Brush logs with soft bristle brush <strong>or</strong> vacuum with brush attachment.• Vacuum loose particles and dust from the front and rear burner, control and piezo covers andgrate weldment.• Inspect and clean burner air intake holes. Remove lint <strong>or</strong> particles with vacuum, brush, <strong>or</strong>pipe cleaners.Failure to keep air intake holes clean will result in sooting and po<strong>or</strong> combustion.• External case should be dusted and wiped with a wet soapy cloth.Annual Cleaning/Inspection - Refer to parts diagram f<strong>or</strong> location of items discussedbelow.• Inspect and clean burner air intake holes. Remove lint <strong>or</strong> particles with vacuum, brush <strong>or</strong>pipe cleaners.Failure to keep air intake holes clean will result in sooting and po<strong>or</strong> combustion.• Inspect and clean all burner p<strong>or</strong>ts.• Inspect ODS pilot f<strong>or</strong> operation and accumulation of lint at air intake holes.• Verify flame pattern and log placement f<strong>or</strong> proper operation.• Verify smooth and responsive ignition of main burner and rear burner.• Replace battery in remote control device.44D0060 27
Change language