FinePix Z2 Manual - Fujifilm Canada

PHOTOGRAPHY FUNCTIONSfi INCREASING MONITOR BRIGHTNESSAvailable Photography modes:AUTO, À, m, ,, ., ©, sThis is useful when checking the shot composition for dimly lit scenes (Slow synchro shots, etc.).Set the Mode switch to “q”.11p PHOTO MODE PHOTOGRAPHY˘ QUALITY MODE (NUMBER OF RECORDED PIXELS)01 021Set the Mode switch to “q”.2Press the “p” button to display the menu on theLCD monitor.The quality setting is retained even when thecamera is off or the mode setting is changed.2N 12UPPress the “fi (a)” button.“ ” appears on the LCD monitor and the subject isdisplayed brightly.To cancel increased brightness:Press the “fi (a)” button again.This function is automatically cancelled after eachshot.●! When this function is active, it will increase the amount ofspeckling in images on the LCD monitor. This is normal anddoes not affect the photographed image.●! This function is purely for checking the composition of yourshot. It does not increase the brightness of the image.●! Even if you increase the brightness in low-light conditions,you cannot check the subject.●! The color tones may vary depending on the subjects.2301 02QUALITYNAUTOSTDPHOTO MODENAUTOSTDPHOTO MODE2592x1944:FN01 0212 FRAMESFN1Press “a” or “b” to select “˘” QUALITY.2Press “c”.1Press “a” or “b” to change the setting.2Press the “MENU/OK” button to confirm thesetting.●! The numbers to the right of setting show the number ofavailable frames.●! When changing the quality setting, the number of availableframes also changes (➡P.24).3Advanced Features38Continued39