condair oem

7.4 Instructions for cleaningCleaning the steam cylinder Type D...Details on cleaning the cleanable steam cylinders Type D... can be found in the separate documentationto this unit component.• Knock off any limescale as much as possible.Note: If the parts are heavily calcified, place them in an 8% formic acid solution, until the limescaledisintegrates.• Then wash parts with a hand-wash temperature soap solution and rinse well.Cleaning the interior of the unitWipe components in the interior of the unit with a damp cloth without cleaning agent. Heavily calcifiedparts, e.g. the drain duct, the drain valve and the inlet valve may be cleaned with normal cleaningand decalcifying agents.Warning! Take care that the electrical connections and the electronic components remain dry.Notes on the cleaning agentThe instructions for use of the cleaning agent must be observed and followed. In particular: detailson personal safety, environmental safety and all restrictions on use.The use of disinfectants is only permitted if they do not leave any toxic residues. The parts mustbe thoroughly rinsed with water after cleaning.Warning! Do not use any solvents, aromatized or halogenized hydrocarbons or other aggressivesubstances.Always maintain local environmental regulations.7.5 Resetting maintenance indication (units with ECCM control only)After completing maintenance work, the maintenance indication can be reset as follows:• Press drain key with the unit switched off and hold down.• Switch on steam humidifier using On/Off switch.• Hold drain key down until the system test is completed (approx. 10 seconds).42