HD-X2 - IRO AB

More documents

Recommendations

Info

Balloon adjustmentHD-X2 19Balloon control adjustment.NOTEExcessive brush tension will cause abnormal wear.Nose PositionMounting position of the nose: 30°, 42° or 55°(55° = standard position)55° 42° 30°Ref. No. 24-893H-2001-02/1232
MaintenanceHD-X2 20CleaningIt is recommended to carry out a periodicalcleaning of any lint or dust accumulation onthe feeder or the control box.min 20 cmlubricationThe unit requires no extra lubrication.ConnectionsMain switchWarningAlways turn off the main switch or isolate thepower supply and disconnect the air supply beforeconnecting or disconnecting the feeder, the controlboard or any of the circuit boards.IRO/ ROJ Tool kitIt is recommended to use IRO tool kit, with specialisedtools, to ensure easy and correct disassembly/ assemblyof IRO feeders during maintenance work.Please contact your local IRO service station for furtherinformation.Ref. No. 24-893H-2001-02/1232
Page 2 and 3: ContentsHD-X2 1Contents............
Page 12 and 13: Voltage supply box / Jumper setting
Page 14 and 15: Speed settingsHD-X2 13NoteNormally
Page 17 and 18: Sensors settingsHD-X2 16The mechani
Page 22 and 23: Assembly instructionsHD-X2 21After
Page 24: Declaration of conformityHD-X2 23IR

HD-X2 - IRO AB

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?