general recommendations - safety - AJ Maskin AS

CORRECTIVE MAINTENANCE SHEETSHEET C006 Sheet 1/1REPLACING THE TILT DETECTORCaution!Do not use the machine duringmaintenance operations.1 - Preliminary operations• Place the platform on a flat, level floor with no slope.• Put the machine in the maintenance configuration (see § 7.2, page 51).• Cut off the electric power supply (see § 7.3, page 52).2 - Removing the tilt detector• Mark and disconnect the tilt detector’s electric connections• Remove the tilt detector by unscrewing the three fixing bolts.3 - Replacing the tilt detector• Put a new tilt detector into place and secure with the three fixing bolts.• Reconnect the electric connections, according to the marks made whendismantling.• Place a spirit level on the top of the tilt detector and adjust the fixingscrews to align the tilt detector.NB:A spirit level is built into certain tilt detectors.• Put the machine back into the operational configuration.4 - Operating test of the tilt detector• Lift the platform to a height of 2m.• Tilt the tilt detector (see photo) and check that a signal is given (the signalshould be audible from the platform).