general recommendations - safety - AJ Maskin AS

3 Repair manual7.5 - OPERATIONS7.5.1 - Summary tableIMPORTANT: If "ORGANIC" OR "EXTREME COLD" OIL IS USED,FREQUENCIES IN THE TABLE BELOW ARE REDUCED BY HALF.FREQUENCY OPERATIONS REFEvery day or beforeeach start ofoperationEvery 50 hoursEvery 250 hours• Check presence and legibility:- of CE manual,- of danger warning stickers,- of instruction stickers.• Check presence of screws etc.• Check levels of:- hydraulic oil (see paragraph 8, sheet P001 )- battery electrolyte.• Check the condition of:- wheel solid tyres,- battery charge on the discharge indicator,- wear of the hydraulic hoses,- hydraulic connections (no leaks),- electric cables and wiring harnesses (no corrosion orstripped areas),- wear of scissor arm slides and pads.• Check proper operation of the tilt detector.• Only the first 50 hours- change the hydraulic filter (see paragraph 8, sheet P002 ).• Check the tightness:- of screws etc. in general,- front motor fixing screws (9 daNm),- rear brake fixing screws (9 daNm),- front wheel nuts (25 daNm),- rear wheel nuts (25 daNm).• Check:- the condition of electric cables (change if corroded),- density of battery electrolyte,- no battery electrolyte leaks.• Check:- the connection of the battery charger,- no cylinder leaks.• Grease:- wheel pivot pins (see paragraph 8, sheet P003 ),- friction parts of the scissor arm slides (see paragraph 8,sheet P004 ).• Change the hydraulic oil filter.• Clean the motor-pump unit ventilation hole.Every 500 hours • Oil change: organic hydraulic oil tank (option) 17Every 1000 hours orevery yearEvery 3000 hours orevery 4 years• Empty:- the hydraulic oil tank,17- the hydraulic circuit.• Clean the motor-pump unit carbon.18• Adjust the pressure limiters.• Check ring wear.• Replace:- hydraulic circuit hoses,- batteries. 191234567891011121314151648