general recommendations - safety - AJ Maskin AS

CORRECTIVE MAINTENANCE SHEETSHEET C007 Sheet 1/1REPLACING A COIL1 - Preliminary operations• Put the machine in the maintenance configuration (see § 7.2, page 51).• Cut off the electric power supply (see § 7.3, page 52).4Compact512 - Removing a coil• Unscrew the two fixing screws (1) from the fixing lug and take out thehydraulic block.• Disconnect the relevant coil’s electric connector (2).• Unscrew the nut (3) or (4) and remove the coil (5).3 - Replacing a coil• Put a new coil (5) into place and secure with the nut (3) or (4).• Reconnect the electric connector (2) on the coil.• Put the hydraulic block back into place and secure with the screws (1)equipped with new flat and toothed washers.• Put the machine back into the operational configuration.Check that the coil works properly by performing the movement corresponding tothe replaced coil.2 3 5451Optimum2 3 5