thread milling - Horn USA, Inc.

THREAD - OVERVIEWPartial profile type 108 and 306DPitchtpiPitchmm108Ds .378" (9.6)smallestminor Ø306Ds .394" (10.0)smallestminor Ø306Ds .461" (11.7)smallestminor Ø48 0.5 R/L108.0205.01 0.42140 R/L108.0205.01 0.42136 R/L108.0205.01 0.42132 0.75 R/L108.0205.01 0.42128 R/L108.0205.01 0.42124 1.0 R/L108.0510.01 0.49620 1.25 R/L108.0510.01 0.496 306.0720.01 0.55118R/L108.0510.01 0.496R/L108.0815.01 0.555306.0720.01 0.55116 1.5 R/L108.0815.01 0.555 306.1020.01 0.465306.0720.01 0.551306.0815.01 0.60614 1.75 R/L108.0815.01 0.555 306.1020.01 0.465306.0720.01 0.551306.0815.01 0.60613306.0720.01 0.551306.0815.01 0.60612 2.0306.0720.01 0.551306.0815.01 0.60611 306.2530.01 0.78710 2.5 306.2530.01 0.7879 306.2530.01 0.7878 3.0 306.2530.01 0.787Dimensions in inch (mm)Full profile Whitworth type 306 and 606Pitch306Ds .394" (10.0)Threadtype606Ds .394 (10.0)Threadtype306Ds .461 (11.7)Threadtype606Ds .461 (11.7)Threadtype11 306.5511.02 G1"14 306.5514.02 G1/2" 606.5514.02 G1/2"19 306.5519.10.22 G1/4" 606.5519.10.22 G1/4" 306.5519.02 G3/8" 606.5519.02 G3/8"Attention:Recutting of the milling tool will create profile errors if the nominal diameter of the component will besmaller than recommended.D4In the UNITED STATES cal us toll free1 - 888 - 818 HORN