13A-16MULTIPORT FUEL INJECTION (MFI)MULTIPORT FUEL INJECTION (MFI) DIAGNOSISOBD- II DRIVE CYCLEAll kinds of diagnostic trouble codes (DTCs) can be monitored by carrying out a short drive according to thefollowing six drive cycle pattern. In other words, doing such a drive regenerates any kind of trouble whichinvolves illuminating the Malfunction Indicator Lamp (SERVICE ENGINE SOON) and verifies the repair procedurehas eliminated the trouble (the Malfunction Indicator Lamp (SERVICE ENGINE SOON) is no longerilluminated).CAUTIONTwo technicians should always be in the vehicle when carrying out a test drive.NOTE: Check that the diagnosis trouble code (DTC) is not output before driving the OBD-II drive cycle. Erasethe DTC if it has been output.DRIVE CYCLE PATTERN LISTPROCEDURE MONITOR ITEM DIAGNOSTIC TROUBLECODE (DTC)1 Evaporative emission system leak monitor P0441, P0442, P0451,P0452, P0453, P0455,P04562 Fuel trim monitor P0171,P01723 Catalytic converter monitor P04214 Heated oxygen sensor monitor P0133, P01395 Exhaust gas recirculation (EGR) system monitor P04016 Other monitor Main components P0134, P0300, P0301,P0302, P0303, P0304,P0506, P0507, P1400Sensors and switches P0101, P0102, P0106,P0107, P0108, P0111,P0112, P0113, P0116,P0117, P0118, P0121,P0122, P0123, P0125,P0181, P0182, P0183,P0335, P0340, P0461,P2066Wire breakage and shortcircuitP0090, P0130, P0131,P0132, P0135, P0136,P0137, P0138, P0141,P0201, P0202, P0203,P0204, P0243, P0403,P0443, P0446.TSB Revision
MULTIPORT FUEL INJECTION (MFI)13A-17MULTIPORT FUEL INJECTION (MFI) DIAGNOSISPROCEDURE 1EVAPORATIVE EMISSION SYSTEM LEAK MONITORDTC P0441, P0442, P0451, P0452, P0453, P0455, P0456Drive cyclepatternThis monitor [from start to ignition switch to the "LOCK" (OFF) position] will be completed while driving the vehiclewith the following drive cycle pattern. It will take 8 minutes. You must complete this drive twice.NOTE: Vehicle speed and throttle opening angle should be within the shaded range.97(60)200 SECONDSOR MORE150 SECONDSOR MORE89 - 97 km/h (55 - 60 mph)M/T: 5TH SPEEDVEHICLE SPEEDkm/h (mph)64(40)32(20)(2)(3)PREPARATIONPERIOD(4)DURINGMONITOR(5)0(1)100ENGINE STARTIGNITION SWITCH:"LOCK" (OFF) positionCALCULATEDLOAD (%)500AKX01345ACInspectionconditions• Engine coolant temperature: 45°C (113°F) or less (The engine is stopped before the test drive is started)• Atmospheric temperature: 5 − 45°C (41 − 113°F)TSB Revision