P.13A-6 - LIL EVO

MULTIPORT FUEL INJECTION (MFI)13A-67MULTIPORT FUEL INJECTION (MFI) DIAGNOSISCONNECTOR: C-115STEP 8. Measure the sensor supply voltage at ECMconnector C-115 by backprobing.(1) Do not disconnect connector C-115.(2) Turn the ignition switch to the "ON" position.HARNESS C-115 (Y)CONNECTOR:COMPONENT SIDE8180 79 78 77 76 75 74 73 72 7192 9190 89 88 87 86 85 84 83 82AK203645ABC-115 HARNESS CONNECTOR: HARNESS SIDE7172 73 74 75 76 77 78 79 80 8182 83 84 85 86 87 88 89 90 9192(3) Measure the voltage between terminal No. 81 and groundby backprobing.• Voltage should measure between 4.8 and 5.2 volts.(4) Turn the ignition switch to the "LOCK" (OFF) position.Q: Is the measured voltage between 4.8 and 5.2 volts?YES : Go to Step 9.NO : Go to Step 10.AK000283AHCONNECTOR: B-105B-105 (B)7 6 5 4 3 2 1HARNESS CONNECTOR:COMPONENT SIDEAK203496ABSTEP 9. Check harness connector B-105 at the barometricpressure sensor and harness connector C-115 at ECM fordamage.Q: Is the harness connector in good condition?YES : Repair harness wire between barometric pressuresensor connector B-105 (terminal No. 1) and ECMconnector C-115 (terminal No. 81) because of opencircuit or harness damage. Then go to Step 18.NO : Repair or replace it. Refer to GROUP 00E, HarnessConnector Inspection P.00E-2. Then go to Step 18.CONNECTOR: C-115HARNESS C-115 (Y)CONNECTOR:COMPONENT SIDE8180 79 78 77 76 75 74 73 72 7192 9190 89 88 87 86 85 84 83 82AK203645ABTSB Revision