P.13A-6 - LIL EVO

MULTIPORT FUEL INJECTION (MFI)13A-41MULTIPORT FUEL INJECTION (MFI) DIAGNOSISCONNECTOR: B-105STEP 2. Measure the reset signal voltage at volume airflowsensor connector B-105 by backprobing.(1) Do not disconnect connector B-105.(2) Turn the ignition switch to the "ON" position.B-105 (B)7 6 5 4 3 2 1HARNESS CONNECTOR:COMPONENT SIDEAK203496ABB-105 HARNESSCONNECTOR:HARNESS SIDE1 2 3 4 5 6 7(3) Measure the voltage between terminal No. 7 and ground bybackprobing.• Voltage should measure between 6.0 and 9.0 volts.(4) Turn the ignition switch to the "LOCK" (OFF) position.Q: Is the measured voltage between 6.0 and 9.0 volts?YES : Go to Step 5.NO : Go to Step 3.AKX01515AHCONNECTOR: B-105STEP 3. Check connector B-105 at volume airflow sensorand connector C-121 at ECM for damage.Q: Is the connector in good condition?YES : Go to Step 4.NO : Repair or replace it. Refer to GROUP 00E, HarnessConnector Inspection P.00E-2. Then go to Step 9.B-105 (B)7 6 5 4 3 2 1HARNESS CONNECTOR:COMPONENT SIDEAK203496ABCONNECTOR: C-121HARNESSCONNECTOR:COMPONENT SIDE13 12 11 10 9 8 7 6 5 4 3 2 126 25 24 23 22 21 20 19 18 17 16 15 14C-121 (Y)AK203488ABTSB Revision