P.13A-6 - LIL EVO

13A-66MULTIPORT FUEL INJECTION (MFI)MULTIPORT FUEL INJECTION (MFI) DIAGNOSISCONNECTOR: B-105B-105 (B)7 6 5 4 3 2 1HARNESS CONNECTOR:COMPONENT SIDEAK203496ABSTEP 6. Check harness connector B-105 at the barometricpressure sensor and harness connector C-115 at ECM fordamage.Q: Is the harness connector in good condition?YES : Repair harness wire between barometric pressuresensor connector B-105 (terminal No. 2) and ECMconnector C-115 (terminal No. 85) because of opencircuit or harness damage. Then go to Step 18.NO : Repair or replace it. Refer to GROUP 00E, HarnessConnector Inspection P.00E-2. Then go to Step 18.CONNECTOR: C-115HARNESS C-115 (Y)CONNECTOR:COMPONENT SIDE8180 79 78 77 76 75 74 73 72 7192 9190 89 88 87 86 85 84 83 82AK203645ABCONNECTOR: B-105STEP 7. Measure the sensor supply voltage at barometricpressure sensor connector B-105 by backprobing.(1) Do not disconnect connector B-105.(2) Turn the ignition switch to the "ON" position.B-105 (B)7 6 5 4 3 2 1HARNESS CONNECTOR:COMPONENT SIDEAK203496AB(3) Measure the voltage between terminal No. 1 and ground bybackprobing.• Voltage should measure between 4.8 and 5.2 volts.(4) Turn the ignition switch to the "LOCK" (OFF) position.B-105 HARNESSCONNECTOR:HARNESS SIDE1 2 3 4 5 6 7Q: Is the measured voltage between 4.8 and 5.2 volts?YES : Go to Step 12.NO : Go to Step 8.AKX01521AHTSB Revision