13.07.2015 Views

P.13A-6 - LIL EVO

P.13A-6 - LIL EVO

P.13A-6 - LIL EVO

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

13A-8MULTIPORT FUEL INJECTION (MFI)MULTIPORT FUEL INJECTION (MFI) DIAGNOSISDTC NO.ITEMSP0243 Turbocharger wastegate solenoid circuitP0300 Random/multiple cylinder misfire detectedP0301 Cylinder 1 misfire detectedP0302 Cylinder 2 misfire detectedP0303 Cylinder 3 misfire detectedP0304 Cylinder 4 misfire detectedP0325 Knock sensor circuitP0335* Crankshaft position sensor circuitP0340* Camshaft position sensor circuitP0401 Exhaust gas recirculation flow insufficient detectedP0403 Exhaust gas recirculation control circuitP0421 Warm up catalyst efficiency below thresholdP0441 Evaporative emission system incorrect purge flowP0442 Evaporative emission system leak detected (Small leak)P0443 Evaporative emission system purge control valve circuitP0446 Evaporative emission system vent control circuitP0451 Evaporative emission system pressure sensor range/performanceP0452 Evaporative emission system pressure sensor low inputP0453 Evaporative emission system pressure sensor high inputP0455 Evaporative emission system leak detected (Gross leak)P0456 Evaporative emission system leak detected (Very small leak)P0461 Fuel level sensor circuit range/performance (sensor 1)P0500 Vehicle speed sensorP0506 Idle control system RPM lower than expectedP0507 Idle control system RPM higher than expectedP0551 Power steering pressure sensor circuit range/performanceP0554 Power steering pressure sensor circuit intermittentP1400 Manifold differential pressure sensor circuit malfunctionP1603* Battery backup circuit malfunctionP2066 Fuel level sensor circuit range/performance (sensor 2)NOTE: If the Malfunction Indicator Lamp (SERVICE ENGINE SOON) illuminates because of a malfunction ofthe engine control module (ECM), communication between the scan tool and the ECM is impossible. In thiscase, the diagnostic trouble code (DTC) cannot be read.NOTE: After the ECM has detected a malfunction, the Malfunction Indicator Lamp (SERVICE ENGINESOON) illuminates when the engine is next turned on and the same malfunction is re-detected. However, foritems marked with a "*" in the DTC NO column, the Malfunction Indicator Lamp (SERVICE ENGINE SOON)illuminates on the first detection of the malfunction.NOTE: After the Malfunction Indicator Lamp (SERVICE ENGINE SOON) illuminates, it will be switched offunder the following conditions..• When the ECM monitored the power train malfunction three times* it met set condition requirements, itdetected no malfunction. *: In this case, "one time" indicates from engine start to stop.TSB Revision

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!