P.13A-6 - LIL EVO

MULTIPORT FUEL INJECTION (MFI)13A-69MULTIPORT FUEL INJECTION (MFI) DIAGNOSISCONNECTOR: B-105STEP 11. Check for short circuit to ground betweenbarometric pressure sensor connector B-105 (terminal No.1) and ECM connector C-115 (terminal No. 81).Q: Is the harness wire in good condition?YES : Replace the ECM. Then go to Step 18.NO : Repair it. Then go to Step 18.B-105 (B)7 6 5 4 3 2 1HARNESS CONNECTOR:COMPONENT SIDEAK203496ABCONNECTOR: C-115HARNESS C-115 (Y)CONNECTOR:COMPONENT SIDE8180 79 78 77 76 75 74 73 72 7192 9190 89 88 87 86 85 84 83 82AK203645ABCONNECTOR: B-105STEP 12. Measure the ground voltage at barometricpressure sensor connector B-105 by backprobing.(1) Do not disconnect connector B-105.(2) Turn the ignition switch to the "ON" position.B-105 (B)7 6 5 4 3 2 1HARNESS CONNECTOR:COMPONENT SIDEAK203496ABB-105 HARNESSCONNECTOR:HARNESS SIDE1 2 3 4 5 6 7(3) Measure the voltage between terminal No. 5 and ground bybackprobing.• Voltage should measure 0.5 volt or less.(4) Turn the ignition switch to the "LOCK" (OFF) position.Q: Is the measured voltage 0.5 volt or less?YES : Go to Step 15.NO : Go to Step 13.AKX01517AHTSB Revision