IPR-12 Manual - Scintrex

KEYPAD AND DISPLAY DESCRIPTIONSC-LINE #- Is the line number of the current electrodes. It follows the sameformat at Station Number.P-LINE # - Is the line number on which the potential electrodes are placed. Itusually is the same as C-Line # but is different in arrays such as the GradientArray. It follows the same format as Station Number.C1, C2 - This is the locat ion of the current electrodes. The format is the same asfor Station Number. It does not matter which electrode is chosen as C1.P1 - P9 - These are the locations of the potential electrodes. The format is thesame as for Station Number.A: - Is called the attribute to the station number and electrode locations. Theresult of the attribute affects how the station number or the electrode locations arechanged by 'MOVE'. It is also used to determine how many dipoles aremeasured.It can have the followin g entries and meanings:+ - increments the respective value if 'Stat.Sep.' is +decrements the respective value is 'Stat.Sep is -- - increments the respective value if 'Stat.Sep' is -decrements the respective value if 'Stat.Sep is +0 - does not change the respective value. Can be used for a fixedcurrent electrode, for instance an infinity electrodex- this electrode is not connected. Do not measure the adjacentdipoles.RECALL - Used to point to the line number and station number for the recallfunction. These parameters can be set here for any valid location, provided therespective data is in memory. This value is automatically updated to the latestlocation every time data is recorded. This makes it simple to recall the previousdata once the reading is recorded. If you are dumping data one line at a time(Output Display), you select the line number on this display, return to the Outputdisplay and select the DUMP ONE LINE parameter. If you want to dump thenext line in the sequence you just press the Enter key from the Output display andthe IPR-12 will automatically advance to the next line and dump the data.3-13