SEL-751A Settings Sheets - CacheFly

Date _______________
SEL-751A Settings Sheets
SET PORT p (p = F, 1, 2, 3, or 4) Command
SET.43
of 66
Volts Reporting Deadband Counts (0–32767)
ANADBV1 :=
(Hidden if ECLASSA1 := 0)
Misc Data Reporting Deadband Counts (0–32767)
ANADBM1 :=
(Hidden if ECLASSA1 := 0 and ECLASSC1 := 0)
Minutes for Request Interval (I, M, 1–32767) TIMERQ1 :=
Seconds to Select/Operate Time-Out (0.0–30.0) STIMEO1 :=
Data Link Retries (0–15) DRETRY1 :=
Seconds to Data Link Time-Out (0–5) (HiddenifDRETRY1:=0) DTIMEO1 :=
Event Message Confirm Time-Out (1–50 sec)) ETIMEO1 :=
Enable Unsolicited Reporting (Y, N)
UNSOL1 :=
(Hidden if ECLASSA1 := 0, ECLASSB1 := 0 and ECLASSC1 := 0)
Enable Unsolicited Reporting at Power-Up (Y, N)
PUNSOL1 :=
(HiddenifUNSOL1:=N)
Number of Events to Transmit On (1–200)
NUMEVE1 :=
(HiddenifUNSOL1:=N)
Oldest Event to Tx On (0.0–99999.0 sec)
AGEEVE1 :=
(HiddenifUNSOL1:=N)
Unsolicited Message Max Retry Attempts (2–10)
URETRY1 :=
(HiddenifUNSOL1:=N)
Unsolicited Message Offline Time-Out (1–5000 sec)
UTIMEO1 :=
(HiddenifUNSOL1:=N)
Minimum Seconds from DCD to TX (0.00–1.00) MINDLY :=
Maximum Seconds from DCD to TX (0.00–1.00) MAXDLY :=
Settle Time from RTS On to TX (OFF, 0.00–30.00 sec) PREDLY :=
Settle Time from TX to RTS OFF (0.00–30.00 sec) PSTDLY :=
Modem Protocol (for DNP3 session and EIA-232 port only)
Modem Connected to Port (Y, N) MODEM :=
Modem Startup String (30 characters) MSTR :=
Phone Number for Dial-Out (30 characters) PH_NUM1 :=
Phone Number for Dial-Out (30 characters) PH_NUM2 :=
Retry Attempts for Phone 1 Dial-Out (1–20) RETRY1 :=
Retry Attempts for Phone 2 Dial-Out (1–20) RETRY2 :=
Time to Attempt Dial (5–300 sec) MDTIME :=
Time Between Dial-Out Attempts (5–3600 sec) MDRET :=
MIRRORED BITS Protocol
(Hidden if PROTO := SEL, EVMSG, or MOD)
MB Transmit Identifier (1–4) TXID :=
MB Receive Identifier (1–4) RXID :=
MB RX Bad Pickup Time (0–10000 seconds) RBADPU :=
PPM MB Channel Bad Pickup (1–10000) CBADPU :=
Date Code 20090501 Instruction Manual SEL-751A Relay