TSM Tool Stand
TSM Tool Stand Manual - ATI Industrial Automation
TSM Tool Stand Manual - ATI Industrial Automation
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Quick-Change Installation and Operation Manual<br />
Document #9610-20-1114-05<br />
3.2 Installing Pin and Bushing or Horizontal V-Block Mounting Module to <strong>Tool</strong><br />
<strong>Stand</strong><br />
1. Refer to the drawing for the model being assembled in Section 9—Drawings. The drawings will provide<br />
torque, thread, and other specific requirements.<br />
2. Assemble the horizontal module to the post module by inserting the T-bolts into the T-slots in the rail.<br />
Turn the T-bolts 90° and torque.<br />
3. Adjust the height of the horizontal module to accommodate the tooling for the application and tighten<br />
the nuts on the T-bolts to secure the vertical position of the rail, further adjustments to horizontal module<br />
may be required.<br />
4. Remove the horizontal module end cap and assemble the mounting module to the horizontal module by<br />
sliding the T-nuts into the T-slots on the horizontal module.<br />
5. Install additional mounting modules if needed.<br />
6. Position the horizontal module and the mounting modules to accommodate the tool spacing desired and<br />
tighten the T-bolts for the horizontal position of the rail. Tighten the M8 socket head cap screws to secure<br />
the mounting modules.<br />
7. Replace the end cap on the horizontal module.<br />
Figure 3.2—Installing <strong>Tool</strong>ing Interface Plates (V-Block Shown)<br />
<strong>Tool</strong> Changer <strong>Tool</strong> Side<br />
End Cap<br />
<strong>Tool</strong>ing Interface Plate<br />
T-Bolt (4)<br />
Mounting Fasteners (6)<br />
<strong>Tool</strong>ing Interface Plate<br />
Horizontal Module<br />
T-slots<br />
T-slots<br />
Mounting Fasteners (6)<br />
End Cap<br />
T-nuts (4)<br />
Mounting Module<br />
T-nuts (4)<br />
Mounting Module<br />
Post Module<br />
Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 • Tel: 919.772.0115 • Fax: 919.772.8259 • www.ati-ia.com • Email: info@ati-ia.com<br />
24