TSM Tool Stand

Quick-Change Installation and Operation Manual
Document #9610-20-1114-05
Figure 3.3—Installing Tooling Interface Plates (Pin and Bushing Shown)
Tool Changer Tool Side
Vertical Tooling Interface Plate
Horizontal Tooling Interface Plate
Mounting Fasteners (6)
End Cap
Tool Changer Tool Side
Vertical Tooling
Interface
Plate
Mounting Module
T-Bolt (4)
T-nuts (4)
T-nuts (4)
T-slots
Post Module
Horizontal Module
Mounting Module
T-slots
T-nuts (4)
Mounting Module
End Cap
8. If equipped, install the optional proximity sensor to the mounting module. Refer to Section 3.6—
Proximity Sensor Module Installation for Pin and Bushing TSM Systems and Section 3.7—Proximity
Sensor Installation for V-Block TSM Systems (Sensor Holder 9120-TSM-SM-4205).
9. If the tooling interface plate is a blank plate it will need to be machined with the mounting pattern for
the Tool Changer and/or customer tooling desired. Refer to Section 9—Drawings for the specific Tool
Changer being used for the mounting pattern required.
10. Assemble the customer tooling and Tool Changer to the tooling interface plate assembly. Then place on
the mounting module. Refer to your Tool Changer manual for proper installation of the tooling interface
plate.
Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 • Tel: 919.772.0115 • Fax: 919.772.8259 • www.ati-ia.com • Email: info@ati-ia.com
25