ServiceManual

More documents

Recommendations

Info

03 FUEL SYSTEM SERVICE MANUAL MARINE ENGINES 11 Remove copper seal washer from bottom side of copper insert by means of hook- and lifting tool (No. VR 00116/0). NOTE: Avoid scratches on the sealing surface of the copper insert. Assembly 02.02 ill.13 1 In order to secure an appropriate tight fit, recheck tighten stud bolt with a torque of 21 Nm +/- 2 02.02 ill.14 2 Drain possible fuel residues by means of suction device No. VR 00121/0 from the combustion chamber. Suction device must be equipped with a suction hose of at least 250 mm of length in order that possible fuel residues can be sucked from piston recess. NOTE: Fuel residues in the combustion chamber may cause severe damage to the engine. 02.02 ill.15 3 Check copper insert for possibly remaining seal washers; remove and dispose, if necessary. NOTE: Always use new copper seal washers! (ill.16/pos.1 ) 1 02.02 ill.16 Page FUEL SYSTEM - 10 Z001019/0_7_July 2012
SERVICE MANUAL MARINE ENGINES 03 FUEL SYSTEM 4 Clean conical part of copper insert with cleaning mandrel No. 2300565/0. For this purpose,, turn cleaning mandrel several times in both directions and then clean copper insert with cleaning tissue. 5 ATTENTION: Insert new special copper seal washer (ill.19/pos.2), from seal kit Z002031/0, with a screwdriver into copper insert. Make sure the copper seal washer is plane. 02.02 ill.17 02.02 ill.18 6 Install new O-rings (ill. 19/pos.1), from seal kit Z002031/0, and cover O-rings with a thin coat of clean motor oil. 1 2 7 Insert unit injector into bore and align unit injector recess to dowel pin (ill. 20/pos.1) for positioning. Avoid any contact with control link. 02.02 ill.19 ATTENTION: Risk of damage to control rack. 1 02.02 ill.20 Z001019/0_7_July 2012 Page FUEL SYSTEM - 11
Page 1 and 2:
STEYR MARINE ENGINES 4 CYLINDERS +
Page 3 and 4:
PREFACE STEYR MOTORS GmbH has devel
Page 5 and 6:
TABLE OF CONTENTS (MAIN ASSEMBLY GR
Page 7 and 8:
05 Cooling system 05.01 Cooler, hea
Page 9 and 10:
ToC SERVICE MANUAL MARINE ENGINES G
Page 11 and 12:
Page 13 and 14:
ToC SERVICE MANUAL MARINE ENGINES A
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
ToC SERVICE MANUAL MARINE ENGINES O
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
ToC SERVICE MANUAL MARINE ENGINES 0
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116: ToC SERVICE MANUAL MARINE ENGINES 0
Page 155 and 156: ToC SERVICE MANUAL MARINE ENGINES R
Page 157 and 158: SERVICE MANUAL MARINE ENGINES 03 FU
Page 165: SERVICE MANUAL MARINE ENGINES 03 FU
Page 193 and 194: SERVICE MANUAL MARINE ENGINES 03.14
Page 201 and 202: SERVICE MANUAL MARINE ENGINES 05 CO
Page 217 and 218:
Page 219 and 220:
Page 221 and 222:
Page 223 and 224:
Page 225 and 226:
Page 227 and 228:
Page 229 and 230:
Page 231 and 232:
Page 233 and 234:
Page 235 and 236:
Page 237 and 238:
Page 239 and 240:
Page 241 and 242:
Page 243 and 244:
Page 245 and 246:
Page 247 and 248:
Page 249 and 250:
Page 251 and 252:
Page 253 and 254:
Page 255 and 256:
Page 257 and 258:
Page 259 and 260:
Page 261 and 262:
Page 263 and 264:
Page 265 and 266:
Page 267 and 268:
Page 269 and 270:
L J 6 5 4 2 3 1 23 ToC SERVICE MANU
Page 271 and 272:
Page 273 and 274:
Page 275 and 276:
Page 277 and 278:
Page 279 and 280:
Page 281 and 282:
Page 283 and 284:
Page 285 and 286:
ToC SERVICE MANUAL MARINE ENGINES I
Page 287 and 288:
ToC SERVICE MANUAL MARINE ENGINES E
Page 289 and 290:
Page 291 and 292:
ToC SERVICE MANUAL MARINE ENGINES I
Page 293 and 294:
Page 295 and 296:
Page 297 and 298:
Page 299 and 300:
°C °F 250 80 40 100 120 0 L MAIN
Page 301 and 302:
°C °F 250 80 40 100 120 0 MAIN RP
Page 303 and 304:
Page 305 and 306:
Page 307 and 308:
Page 309 and 310:
Page 311 and 312:
Page 313 and 314:
Page 315 and 316:
Page 317 and 318:
Page 319 and 320:
Page 321 and 322:
Page 323 and 324:
Page 325 and 326:
Page 327 and 328:
Page 329 and 330:
Page 331:
show all

ServiceManual

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?