ServiceManual

More documents

Recommendations

Info

ToC 06 ELECTRICAL SYSTEM SERVICE MANUAL MARINE ENGINES 06.06.03 Reading Error Codes Entering and reading of stored faults via Check Engine Lamp and Diagnostic Outlet Plug ( X 23 ): Needed device: Tool No. VR00135/1 ( normally closed push button switch ) connected to Diagnostic Outlet Plug X23. In case this tool is not available: Connect temporarily Pin - Pos. 1 with Pin - Pos. 2 of Diagnostic Plug X 23 ( before ignition is turned on at key switch ) Code indication and indication sequence: 06.03 ill.1 After entering the error code indication modus the Engine Management System will display a blink code at the Check Engine Light on the dash panel. The blinking sequence will always begin and end with control code indication # 12. Each ERROR CODE will be repeated 3 times to reassure your correct reading – see below bar code illustration. Example sequence check engine light (ill.2/pos.1): Error code # 14 1 06.03 ill.2 06.03 ill.3 Stroke = Check Engine Light illuminated for 0,3 sec. (Light Off - period within blink sequence 0,4 sec.) Dashed Line = interruption within code indication 1,5 sec. Solid Line = interval interruption between error code 3,0 sec. Page ELECTRICAL SYSTEM - 38 Z001019/0_6_July 2008
ToC SERVICE MANUAL MARINE ENGINES 06 ELECTRICAL SYSTEM If more then one error code is stored in the Engine Management System the indication sequence will be continued blinking additional stored error codes. To delete a memorized error code see description Indication and Cancellation of memorized sensor and circuit faults. For a description of the possible error codes refer to enclosed Table – Error Codes ATTENTION: To exit from Error code indication. Tool VR00135/1 must be removed ( connection between Pin 1 to Pin 2 opened ) before ignition is turned ON again. 06.06.04 Indication and Cancellation of memorized sensor and circuit faults Selection and clearing of stored error codes: Procedure: * Ignition — OFF * Connect Tool VR00135/1 to Diagnostic Outlet Plug ( X 23 ) – see 06.03 ill.1 * Ignition — ON Note: The program changes automatically to indication of error codes. If no error code is stored, only repeating control code reading “ CODE # 12 “ will be displayed. Possible memorized codes are indicated as shown in the previous illustrated example ( blinking 3x CODE # 12 i. e. 3x ERROR CODE # 14 etc. ) The sequence will be prolonged with additional codes if more then one ERROR CODE is stored. See Table – ERROR CODES for description * To delete a determined ERROR CODE from the Engine Management System concentrate for the 3 rd times flashing the desired ERROR CODE. While this ERROR CODE is displayed the third time the button ( Tool VR00135/1 ) must be pushed and kept in this position ( contact open ). * The indication on the Check Engine Light changes to a fast blinking of the lamp ( app. 4 times per sec. ). During this rapid flashing light the push button must be released ( close contact after app. 2 sec.) to delete this ERROR CODE. Note: Any other ERROR CODE have to be selected and cleared individually following the above mentioned procedure to delete a determined ERROR CODE. Note: An ERROR CODE can only be deleted if no defect exists in this circuit. In case of a present active failure, the ERROR CODE keeps reappearing until the problem has been repaired and the circuit is properly working again. * Disconnect Tool VR00135/1 from Diagnostic Outlet Plug ( X 23 ) to exit from error code display. Note: Watch indication of the Check Engine Light and the Warning Horn after ignition contact. If all ERROR CODES are deleted from the Engine Management System the indication resumes to 0.7 sec. function test of Check Engine Light and the Warning Horn. For more details see Chart – Operating Conditions - Instrument panel. Z001019/0_6_July 2008 Page ELECTRICAL SYSTEM - 39
Page 1 and 2:
STEYR MARINE ENGINES 4 CYLINDERS +
Page 3 and 4:
PREFACE STEYR MOTORS GmbH has devel
Page 5 and 6:
TABLE OF CONTENTS (MAIN ASSEMBLY GR
Page 7 and 8:
05 Cooling system 05.01 Cooler, hea
Page 9 and 10:
ToC SERVICE MANUAL MARINE ENGINES G
Page 11 and 12:
Page 13 and 14:
ToC SERVICE MANUAL MARINE ENGINES A
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
ToC SERVICE MANUAL MARINE ENGINES O
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
ToC SERVICE MANUAL MARINE ENGINES 0
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Page 155 and 156:
ToC SERVICE MANUAL MARINE ENGINES R
Page 157 and 158:
SERVICE MANUAL MARINE ENGINES 03 FU
Page 159 and 160:
Page 161 and 162:
Page 163 and 164:
Page 165 and 166:
Page 167 and 168:
Page 169 and 170:
Page 171 and 172:
Page 173 and 174:
Page 175 and 176:
Page 177 and 178:
Page 179 and 180:
Page 181 and 182:
Page 183 and 184:
Page 185 and 186:
Page 187 and 188:
Page 189 and 190:
Page 191 and 192:
Page 193 and 194:
SERVICE MANUAL MARINE ENGINES 03.14
Page 195 and 196:
Page 197 and 198:
Page 199 and 200:
Page 201 and 202:
SERVICE MANUAL MARINE ENGINES 05 CO
Page 203 and 204:
Page 205 and 206:
Page 207 and 208:
Page 209 and 210:
Page 211 and 212:
Page 213 and 214:
Page 215 and 216:
Page 217 and 218:
Page 219 and 220:
Page 221 and 222:
Page 223 and 224: ToC SERVICE MANUAL MARINE ENGINES 0
Page 269 and 270: L J 6 5 4 2 3 1 23 ToC SERVICE MANU
Page 273: ToC SERVICE MANUAL MARINE ENGINES 0
Page 285 and 286: ToC SERVICE MANUAL MARINE ENGINES I
Page 287 and 288: ToC SERVICE MANUAL MARINE ENGINES E
Page 291 and 292: ToC SERVICE MANUAL MARINE ENGINES I
Page 299 and 300: °C °F 250 80 40 100 120 0 L MAIN
Page 301 and 302: °C °F 250 80 40 100 120 0 MAIN RP
Page 325 and 326:
ToC SERVICE MANUAL MARINE ENGINES E
Page 327 and 328:
Page 329 and 330:
Page 331:
show all

ServiceManual

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?