COGNEX DM100_200 ControlCommands - Bci GmbH

DMCC Overview
DataMan Control Commands Documentation 3.5
Communication Commands
Set/Get Command Arguments Range Meaning Description
SET|GET COM.USB-
COMPATIBILITY-MODE
legacy
SET|GET COM.BAUD-RATE rate
SET|GET COM.PARITY parity
[ON|OFF] ON: use pre-
3.5.0 driver
OFF: default
[0-5]
[0-2]
SET|GET COM.DATA-BITS bits [7,8]
SET|GET COM.STOP-BITS bits [1-8]
SET|GET COM.DMCC-RESPONSE mode
SET|GET DATA.RESULT-
ENCODING
encoding
0: 230400
1: 115200
2: 57600
3: 38400
4: 19200
5: 9600
0: None
1: Even
2: Odd
[0|1] 0: Silent
(default)
1: Extended
[0|1] 0: ASCII
(default)
1: Base64
Controls USB driver.
Reboot is required.
DM100 and DM700
series only.
DMCC response format
Result string encoding.
SET|GET COM.XLATEPRNT state [ON|OFF] enable/disable Translate unprintable
characters that are
embedded in a symbol.
The translated result is
output over the
connection (e.g. COM,
USB, Ethernet, USB-
KEYBOARD). Note that
Data Formatting leading
and terminating text are
not translated. The
characters translated
are ASCII values
between 0x00 and 0x1F.
For example, 0x00 =
, 0x04 = ,
0x0a = , 0x0d =
.
GET DEVICE.MAC-ADDRESS Reader's MAC address
DM200 series only
SET|GET ETHERNET-IP.ENABLED state [ON|OFF] enable/disable Enabled or disabled
EtherNet/IP
communications.
DM200 series only
SET|GET NET-LOCAL.IP-ADDRESS string Reader's IP address
Uses dotted decimal
form, such as
"192.168.23.42"
DM200 series only
SET|GET NET-LOCAL.SUBNET-
MASK
Page 20 of 24
string Reader's subnet mask
Uses dotted decimal
form, such as
"192.168.23.255"
DM200 series only
SET|GET NET-LOCAL.DHCP state [ON|OFF] enable/disable Enable/Disable DHCP on
reader
DM200 series only
file://C:\Dokumente und Einstellungen\schiermann\Lokale Einstellungen\Temp\~hh7...
27.12.2010