SpaceClaim 2011 Release Notes
SpaceClaim 2011 Release Notes
SpaceClaim 2011 Release Notes
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>SpaceClaim</strong> <strong>2011</strong> <strong>Release</strong> <strong>Notes</strong><br />
When you are pulling a point on a surface in a direction, such as towards an Alt+clicked vertex, as shown<br />
in the figure, the Pull tool no longer switches from the Direction tool guide to the Scale tool guide.<br />
You can pivot multiple separate, planar edges simultaneously, as shown in the following figure.<br />
Baseline faces now remain contiguous when you make rounds on a shelled solid:<br />
To create a round across a gap, select the Pull tool, select two faces that would meet at a corner, then<br />
click the Round tool option to preview the round, as shown in the figure. Pull to create the round.<br />
Previously, the size of the gap that could be spanned was limited by the size of the edge round that could<br />
be created on one of the edges.<br />
On geometry similar to that shown in the figure, you can now pull the rounds in the selected tangent<br />
chain without changing the round shown in blue:<br />
www.spaceclaim.com<br />
Page 13
Change language