SpaceClaim 2011 Release Notes

SpaceClaim 2011 Release Notes
Circular and Smooth Edge Reliefs are now available from the Edge Relief option tool in the Modify ribbon
group and from the mini-toolbar. The geometry is fully visible in an unfolded state.
There is no longer a bend relief depth or width property for circular or smooth edge reliefs.
The Corner Relief tool was removed from the Create ribbon group because corner reliefs are created
automatically while creating sheet metal or when converting to sheet metal with the Convert tool. The
Corner Relief option tool allows you to modify the default corner relief type.
You can now select multiple corner reliefs to change them all to another type.
If the bends neighboring a corner relief are equal, you can select the bends, then select the Smooth
option from the Corner Relief tool to modify the corner relief.
The properties of a corner relief now reflect the type of corner relief except that the Smooth type is not
shown for unequal radius or angles, and the Diagonal type is not shown for equal radius or angles. (Largeangle
corners also do not work.)
You can now select the Smooth option from the Corner Relief option tool for unequal radius bends and
non-90-degree corners:
You can now select Laser Symmetric from the Corner Relief option tool when you select an existing corner
relief to change its type:
The Default corner relief was added to the mini-toolbar. The None corner relief type was renamed to
Filled.
You can now return a corner relief from the Filled type to the Default type by selecting the vertex where
the corner relief would be, then selecting the Default option from the Corner Relief option tool.
www.spaceclaim.com
Page 23