Weidmueller PLC-interface units, front adapters and prefabricated cables.

RS RJ45 - Interfaces with RJ45 connector
Passive interfaces transport signals from a modem, router,
computer or any other communications equipment using
RJ45 connectors to screw or tension clamp connections.
They can be used to adapt the shielded RJ-45 8-pole
connectors to screw connections or for coupling 2 data
lines.
For data transmission rates of up to 100 Mbps, it is
advisable to connect one end of the shield of the data
cable to a protective earth.
Introduction
The ELCO connectors are used, for example, in electric
power stations, refineries and in different processing
applications in which a robust, reliable connection is
needed for a large number of signals. The main feature of an
ELCO connector is its reliability thanks to its hermaphrodite
contact, which is shaped like a fork.
The diagonal disposition of the connector (from right to left)
facilitates the wiring of the cables in the electrical cabinet
and avoids them from crossing one other.
RS VERT – Supply voltage distributor modules
Passive interfaces for the distribution of AC or DC voltage
These interfaces can distribute from 2 to 6 different voltages.
This allows distributing voltages of 230/400 V AC and DC
control signals.
These interfaces provide an easy visualisation, and can be
fixed to standard TS35 and/or TS32 assembly rails.
Passive interfaces for general applications
D
The modules can be fixed to standard TS32 and/or TS35
mounting rails.
RS ELCO – Interface with ELCO plug-in connectors
Passive interfaces that transport signals proceeding from a
20 to 90-pole male/female ELCO plug-in connector to screw
or tension clamp connection techniques.
2021570000
D.3