Weidmueller PLC-interface units, front adapters and prefabricated cables.

Introduction
Pre-assembled cables
for general applications
Pre-assembled cables for general applications
Pre-assembled cables with the corresponding plug-in
connector systems are used in the connection between the
controller and the interface. These pre-assembled cables
allow maximum savings for the user, as they achieve a cost
reduction in the materials, due to fewer individual cables,
conductors and cable ducting.
PAC-ELCO Pre-assembled cables for RS ELCO
interfaces
PAC-UNIV Pre-assembled cables for RS F and
RS SD interfaces
F
With pre-assembled cables for ELCO connectors, one end of
the cable is prepared for connecting with the RS-ELCO
interfaces. The other end is connected to a wire-end ferrule
or to a female ELCO connector. Colour code acc. To
DIN 47,100 and available in different lengths.
PAC-UNIV Pre-assembled cables with PLC original
connector
This range of pre-assembled cables for ribbon cabling
complies with IEC 60603-13/DIN41651 SUB-D in
accordance with IEC 60807-2/DIN41652 and Sub-D High
density.
One end of the cable is prepared for connecting with the
RS-F or RS SD interfaces and the other end for wire-end
ferrules or to a SUB-D connector or ribbon cable.
Colour code acc. To DIN 47,100 and available in different
lengths.
These range of pre-assembled cables are provided with the
original PLC connector in one end of the cables and with
ferrules in the other.
Colour code acc. To DIN 47,100 and available in different
lengths.
Avaliable for main PLC‘s of the market. More options on
demand.
F.2 2021570000