Configuration Manual AC Induction Motors 1PH4 - Siemens ...

x
Foreword
Caution
� Motors should be connected–up according to the circuit diagram provided.
They must not be connected directly to the three–phase supply because this
will damage them.
� SIMODRIVE drive units with AC motors are subject to a voltage test, in
compliance with EN 50178 as part of a routine test. While the electrical
equipment of industrial machines is being subject to a voltage test in
accordance with EN60204–1, Section 19.4, all SIMODRIVE drive unit
connections must be disconnected/withdrawn in order to avoid damaging the
SIMODRIVE drive units.
Notes
� SIMODRIVE units with AC motors fulfill, when operational and in dry operating
rooms, the Low–Voltage Directive 73/23/EEC.
� SIMODRIVE units with AC motors fulfill, in the configuration specified in the
associated EC Declaration of Conformity, the EMC Directive 89/336/EEC.
© Siemens AG 2003 – 2006 All rights reserved
AC Induction Motors, 1PH4 (APH4) – 04.06 Edition