Configuration Manual AC Induction Motors 1PH4 - Siemens ...

Foreword
Commissioning software
Additional commissioning software is available to commission AC induction motors
connected to the SIMODRIVE drive converter system.
vi
Order No. [MLFB] for software 6SN1153–2AX10–�AB�5
Order No. [MLFB] for documentation 6SN1197–0AA30–0�B�
Technical Support
Should you have any questions about our products, then please contact the following
hotline:
Europe/Africa Asia/Australia America
Phone +49 (0) 180 5050–222 +86 1064 719 990 +1 423 262 2522
Fax +49 (0) 180 5050–223 +86 1064 747 474 +1 423 262 2289
Internet http://www.siemens.com/automation/support–request
E–mail mailto:adsupport@siemens.com
Questions regarding documentation
If you have any questions (suggestions, corrections) regarding this documentation,
please fax or e–mail us at:
Fax: +49 (0) 9131 / 98–63315
E–Mail: mailto:motioncontrol.docu@siemens.com
Fax form: Please see the feedback form at the end of this document.
Internet address for products
http://www.siemens.com/motioncontrol
Correct usage
Please carefully note the following:
The equipment may only be used for applications described in the catalog or in the
Configuration Manual, and only in combination with devices or components from
other manufacturers which have been approved or recommended by Siemens.
The successful and safe operation of this equipment and motors is dependent on
professional transport, storage, installation and mounting as well as careful operator
control, service and maintenance.
© Siemens AG 2003 – 2006 All rights reserved
AC Induction Motors, 1PH4 (APH4) – 04.06 Edition