Configuration Manual AC Induction Motors 1PH4 - Siemens ...
Configuration Manual AC Induction Motors 1PH4 - Siemens ...
Configuration Manual AC Induction Motors 1PH4 - Siemens ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Motor Description<br />
1.9 Mounting<br />
1.9 Mounting<br />
Mounting instructions<br />
!<br />
!<br />
1-30<br />
Warning<br />
These motors are electrically operated. When electrical equipment is operated, certain<br />
parts of these motors are at hazardous voltage levels. If this motor is not correctly<br />
handled/operated, this can result in death or severe bodily injury as well as significant<br />
material damage. Please carefully observe the warning information in this section an<br />
on the product itself.<br />
� Only qualified personnel may carry–out service or repair work on this motor.<br />
� Before starting any work, the motor must be disconnected from the line supply<br />
and grounded.<br />
� Only spare parts, certified by the manufacturer, may be used.<br />
� The specified service/maintenance intervals and measures as well as the<br />
procedures for repair and replacement must be carefully maintained and<br />
observed.<br />
Warning<br />
� When transporting the motors, use all of the hoisting lugs provided!<br />
� All work should be undertaken with the system in a no–voltage condition!<br />
� The motor should be connected up according to the circuit diagram provided.<br />
� In the terminal box it must be ensure that the connecting cables are insulated<br />
with respect to the terminal board cover.<br />
� After the motor has been installed, the brake (if one is used) must be checked<br />
to ensure that it is functioning perfectly!<br />
Note<br />
Flange mounting is only possible using studs and nuts. Clearance M1 for threading<br />
the nut between the motor flange and motor frame acc. to DIN 42677 (refer to<br />
Table 1-12).<br />
Table 1-12 Flange mounting with studs and nuts<br />
Shaft height M1 [mm]<br />
100 44<br />
132 50<br />
160 65 M1<br />
<strong>1PH4</strong><br />
© <strong>Siemens</strong> AG 2003 – 2006 All rights reserved<br />
<strong>AC</strong> <strong>Induction</strong> <strong>Motors</strong>, <strong>1PH4</strong> (APH4) – 04.06 Edition