Configuration Manual AC Induction Motors 1PH4 - Siemens ...

Motor Description
1.4 Order designation
Additional data for options
Option Short designation
Terminal box arrangement (when viewing the DE)
� On right side
� On left side
� Small terminal box and signal connector connection turned through 90��(cable
entry from DE)
� Small terminal box and signal connector connection turned through 90��(cable
entry from NDE)
� Small terminal box and signal connector connection turned through 180�
Bearing version on DE
� Single bearing for coupling or planetary gear units or low to moderate cantilever
forces
� Single bearing for increased speeds
� Rotary shaft seal, oil–tight
Vibration severity (acc. to IEC 34–14, DIN VDE 0530, Part 14)
� Grade S with duplex bearing
� Grade S with single bearing
� Grade SR with single bearing
1-20
K09
K10
K83
K84
K85
K00
L37
K18
K05 1) 4)
K02 1) 4)
K03 1) 4)
Shaft and flange accuracy (acc. to DIN 42955)
� Tolerance R K04 2)
DE shaft end
� NDE shaft end (without keyway) K42
Balancing
� Half–key balancing L69
Gearbox 5)
� Motor prepared for mounting a ZF selector gearbox 2LG43 K00 3)
Holding brake
� Motor with mounted holding brake (DE) G46 4)
Miscellaneous
� 2nd rating plate, supplied loose
� No encoder system
K31
H30
1) Automatically includes version K04.
2) Increased shaft accuracy
3) For gearboxes 2LG42 (old version), use G97+K00; G97;
G97 = non–standard cylindrical shaft end for SH 100, SE ∅ 28 x 60 mm
4) Cannot be combined with gearbox mounting
5) There must be a seal between motor flange and gearbox flange at SH 132 and SH160 due to the uninterrupted
centering shoulder with sealing compound (e.g. Terostat 93, Teroson).
© Siemens AG 2003 – 2006 All rights reserved
AC Induction Motors, 1PH4 (APH4) – 04.06 Edition