Single pull macgregor type hatch cover.pdf - Cochin University of ...

CHAPTER 6 - FABRICATION
The design was made with the specific dimensions and was submitted to project guide
for approval. After making necessary changes as directed by the project guide, the
design was approved. After the approval, team started the fabrication work which is
explained in this chapter.
6.1 FABRICATION OF CARGO HOLD
Ply wood material dimensions brought into workshop:
8 ft×6 ft: One piece
6 ft×4 ft: Two pieces
4 ft× 4 ft: One piece
Figure 6.1: Cargo Hold
Source: Team
Placed on the work table and marked the dimensions as follows:
120 cm×63.3 cm (bulkhead separation forward)
120 cm×63.3 cm (bulkhead separation aft)
150 cm×63.3 cm (side plate starboard)
150 cm×63.3 cm (side plate port)
67