The Official JungleFlasher User Guide

For your information:
Trace cuts!
Cutting traces on the PCB: The traces that requires cutting on the PCB are only a thin strip of
copper laid on top of the PCB! They do NOT need carving up with a chainsaw! A reasonable
pressure with a sharp craft knife is sufficient to cut through them. Easily less than .5mm thick!
Moral of the story: You don’t have to cut right through half the PCB to cut the trace!
Click on the link for the method of your choice!
The MRA Hack
Xecuter Probe II , Xecuter LT Switch
Vampire With Board , Vampire w/o Board
Please Note: The following methods have been superseded by PMT
Probe, As such the Jungleflasher Version shown in the pictures are
OLDER and the layout differs slightly to current version – The methods
still work – just the buttons may have moved slightly from shown.
Page 116 of 223
Things not going as expected? – Read the FAQ’s