The Official JungleFlasher User Guide

Xecuter Probe II Method
Connect the Xecuter probe II to the CK3 Pro.
Make sure the OP Switch is in the UP (ON) position and switch the mode to MRA.
Power on the CK3 pro you will see that the Xecuter probe II BLUE POWER LED is on and the MRA
GREEN NORMAL LED is on (IF RED is LIT – op-switch is in WRONG position). This shows that
everything is functioning.
Now turn the CK3 Pro power OFF.
Use a fiberglass scratch pen and clean up the 2 holes to make the Probes contact better – Do this
before cutting traces, as you are less likely to stress the pad 101 while it’s still connected to trace
Cut traces on the PCB. The cuts are small and not difficult to do. Most people use a Xacto knife or a
small dremel tool. Make 2 small cuts where the yellow lines are. . (Be very careful not to damage
pad 101, once cut from the trace it becomes quite fragile)
Page 130 of 223
Things not going as expected? – Read the FAQ’s