The Official JungleFlasher User Guide

Dumping Firmware from a drive with a Xecuter LT Switch Fitted
For full fitting instructions go here
Essentially the board preparation is the similar to the MRA hack but once fitted
need not be removed and has a switch on it to select between ‘normal’ operation
and R/W (presumably meaning read/write) though technically all reading and
writing is done with switch in ‘normal’ position, the R/W position is ONLY used to
place the drive into vendor mode!, then switched back to normal for reading and
writing operations.
NOTE: v1.5 has now been released! Added MULTI-R feature! Select 20ohms
normally – if drive status fails to leave 0x51, try selecting 18ohms or 22ohms and
try again.
Once installed as per fitting instructions,
With switch in “Normal” position and MULTI-R set to 20 ohms
Connect drive to PC’s SATA and power drive (GREEN LED will be LIT), select MTK
Flash32 tab
Refresh, drive properties – so drive shows up
Page 124 of 223
Things not going as expected? – Read the FAQ’s