The Official JungleFlasher User Guide

My Xbox keeps turning itself off while I’m trying to flash my drive
If you are using the Xbox to power your drive during flashing, you MUST
have the AV cable plugged into the Xbox (other end does NOT need to be
connected to TV), otherwise it will power down after a few minutes
(disaster if you are flashing a Hitachi). The HDMI cable can be used instead
but it MUST BE connected to the TV!
It keeps saying serial data missing? OMG what do I do?
There is the option to rebuild the serial data from the serial numbers on the
LiteOn case, laser and PCB. You can proceed and fill this data in IF YOU
WISH! Go HERE for instructions on how. But – remember if the data is
missing from the drive, do you really want to add it now? If it’s a brand new
drive that’s not been touched before then it may be advisable to leave it!
I am trying to insert the unlock79 CD but I press twice to close and it opens
again!
This is fairly common, in mode B some drives take 3 presses of eject button
instead of 2 to get the drive to stay closed!
Every time I connect my drive to my VIA card my PC slows down or freezes
Try reading the tutorial………….! Remove your drivers for the card!
Instructions for how to do it properly are HERE. OR in the less likely event
that you have already correctly removed the drivers from the card and it
still freezes – try moving your card into another PCI slot! (You may be
required to reinstall drivers then remove using same method as before)
I just flashed my LiteOn – placed in a game and it doesn’t work – OMG!
Before you panic – try ejecting then closing, and then reboot the console!
It’s possible the tray wasn’t fully closed when the console booted and 0800
mode was activated (ix 1.6-1.61 only) – causing an error!
Page 218 of 223
Things not going as expected? – Read the FAQ’s