07.02.2013 Views

2012 Chrysler Town & Country Users Guide

2012 Chrysler Town & Country Users Guide

2012 Chrysler Town & Country Users Guide

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Sound Horn With Lock<br />

• To turn the horn chirp on or off when the doors are locked:<br />

• Press the LOCK button for at least 4 seconds, but no longer than 10 seconds. Then,<br />

press the PANIC button while still holding the LOCK button.<br />

• Release both buttons at the same time.<br />

Flashing Lights With Lock<br />

ELECTRONICS<br />

• The turn signal lights flashing, when the doors are locked or unlocked, feature can be<br />

turned on or off. To turn this feature on or off:<br />

• Press and hold the UNLOCK button for at least 4 seconds, but no longer than<br />

10 seconds. Then, press and hold the LOCK button while still holding the UNLOCK<br />

button.<br />

• Release both buttons at the same time.<br />

UNIVERSAL GARAGE DOOR OPENER (HomeLink®)<br />

• HomeLink® replaces up to three hand-held transmitters that operate devices such as<br />

garage door openers, motorized gates, lighting or home security systems. The<br />

HomeLink® unit is powered by your vehicles 12 Volt battery.<br />

• The HomeLink® buttons that are located in the overhead console or sunvisor designate<br />

the three different HomeLink® channels.<br />

• The HomeLink® indicator is located above the center button.<br />

Before You Begin Programming<br />

HomeLink®<br />

• Be sure that your vehicle is parked outside<br />

of the garage before you begin<br />

programming.<br />

• For more efficient programming and<br />

accurate transmission of the<br />

radio-frequency signal it is recommended<br />

that a new battery be placed in the<br />

hand-held transmitter of the device that is<br />

being programmed to the HomeLink®<br />

system.<br />

• Erase all channels before you begin programming. To erase the channels, place the<br />

ignition switch into the ON/RUN position, then press and hold the two outside<br />

HomeLink® buttons (I and III) for up 20 seconds or until the red indicator flashes.<br />

NOTE:<br />

• Erasing all channels should only be performed when programming HomeLink® for the first<br />

time. Do not erase channels when programming additional buttons.<br />

• If you have any problems, or require assistance, please call toll-free 1–800–355–3515 or, on<br />

the Internet at www.HomeLink.com for information or assistance.<br />

77

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!