INSTALLATION INSTRUCTIONS

3. SELECTING THE LOCATION FOR THE INDOOR UNIT
3-1. Required Minimum Space for Installation and Service.
Provide a check port on the piping side ceiling for repair and maintenance.
Install the indoor unit once the following conditions are satisfied and after receiving the customer approval.
1. The indoor unit must be within a maintenance space.
2. The indoor unit must be free from any obstacles in path of the air inlet and outlet, and must allow spreading of air
throughout the room.
Top view
(Unit:mm) Inspection hole
(600 x 600)
600
1000
600
Control box
Front view
If the height from the floor to ceiling exceeds three meters, air flow distribution deteriorates and the effect is
decreased.
POSITION OF SUPENSION BOLT Apply a joint-canvas between the unit and duct to absorb unnecessary
vibration.
A
Install the unit leaning to a drainage hole side as a figure for easy water
B
drainage.
D
C
E
(Unit:mm)
TYPE
S-36PN1E5
A B C D E
S-45PN1E5
S-50PN1E5
840 780 523 64 650
S-60PN1E5
S-71PN1E5
S-100PN1E5
1060 1000 523 64 650
S-125PN1E5
S-140PN1E5
1260 1200 523 64 650
7
Above 250cm
Absorber
1~3mm
Drainage hole
Caution
Remove the absorber at air return
hole before installation.
Fig.3-1
Fig.3-1.1
ENGLISH
��������� E������� PORTUGUÊS
�������
����������