MANUALE PER L'INSTALLAZIONE - enrdd.com
MANUALE PER L'INSTALLAZIONE - enrdd.com
MANUALE PER L'INSTALLAZIONE - enrdd.com
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
1<br />
1.1 Minimum distances<br />
To ensure the appliance is installed correctly, keep to the<br />
minimum distances indicated in figure “A” and leave<br />
enough room for air to circulate freely.<br />
Use the accessories provided with the appliance to<br />
carry out the installation properly.<br />
Note:<br />
The dimensions of the internal and external units are<br />
given at the back of the manual.<br />
ATTENTION:<br />
- Make sure the installation site and any systems to which<br />
the appliance must be connected <strong>com</strong>ply with the applicable<br />
norms in force.<br />
- Use manual tools and equipment suitable for the intended<br />
use (in particular, make sure that the tool is not worn and<br />
that the handle is intact and fully fastened to the rest of the<br />
tool); use them correctly and make sure they don’t fall from<br />
a height. Put them safely back in place after use.<br />
(risk of personal injury from falling splinters or fragments,<br />
and damage to the appliance and surrounding objects).<br />
- When lifting loads with a crane or hoist, make sure the<br />
equipment used for lifting is stable and efficient and suitably<br />
sized for the movement and weight of the load itself;<br />
place the load correctly in slings, tie ropes around it to limit<br />
any oscillations and lateral movements; lift the load from a<br />
position where there is a full view of all the space covered<br />
by the load during lifting; do not allow people to pass or<br />
stop in the vicinity of the suspended load.<br />
1.2 Installing the template<br />
ATTENTION:<br />
install the template on a solid wall that is not subjected to<br />
any vibrations.<br />
1. Using a mason’s level, position the template in such a<br />
way as to ensure it is perfectly on-axis, both vertically and<br />
horizontally.<br />
2. Initially, fasten the template with 5 screws.<br />
Be careful not to pierce or damage any pipes or wiring in<br />
conduits (risk of personal injury from electrocution).<br />
3. Then use the other screws to fasten the template to the<br />
wall uniformly on all its surface.<br />
4. Make a hole in the wall for all piping and electrical connections<br />
to pass through.<br />
INSTALLATION<br />
INTERNAL<br />
UNIT<br />
EXTERNAL<br />
UNIT<br />
293<br />
ø 65<br />
300<br />
250<br />
ø 65<br />
250<br />
600<br />
300<br />
150<br />
300<br />
600<br />
600<br />
7000 - 9000 - 12000<br />
150<br />
750<br />
300<br />
18000 - 24000 - 9000+9000 - 12000+9000<br />
150<br />
920<br />
fig. “A”<br />
250<br />
250<br />
ø 65<br />
45<br />
250<br />
ø 65<br />
50<br />
21