KORG SV-1 1.0 User GUIDE (EFGI1) - Scavino
KORG SV-1 1.0 User GUIDE (EFGI1) - Scavino
KORG SV-1 1.0 User GUIDE (EFGI1) - Scavino
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Troubleshooting | Problems and solutions – 33<br />
Troubleshooting<br />
English<br />
If you suspect a malfunction, please check the following points first. If this does<br />
not resolve the problem, please contact your dealer or Korg Authorized Service<br />
Center.<br />
Problem Possible remedy Page<br />
The instrument<br />
will not turn on<br />
No sound<br />
Check that the AC cable is not damaged, and it is correctly connected<br />
to the piano and the outlet.<br />
Make sure that the volume is not set on 0. If it is, bring it up to an<br />
adequate level.<br />
Make sure that the Local Off function is not turned on. If it is, turn it<br />
off.<br />
If you are listening in headphones, make sure the jack is correctly<br />
plugged into the HEADPHONES connector.<br />
Make sure there isn’t one of the following control settings:<br />
• Pre-FX Comp: Intensity = 0<br />
• Pre-FX Boost: Intensity = 0<br />
• Amp Models: Drive = 0<br />
The valve might still be “warming up”. Please wait some seconds.<br />
This isn’t a malfunction – it’s a real analogue valve!<br />
Something missing If you are using the XLR outputs, make sure you have connected<br />
both outputs. Mono output is not possible with the XLR jacks.<br />
Weak sound The valve may be exhausted. Please refer to the nearest Korg Authorized<br />
Service Center for replacement.<br />
Noisy audio Cables may be too long, or get interference from other devices on<br />
the stage. Use the XLR connectors instead.<br />
If the AMP MODEL is turned on, you might be listening to the natural<br />
noise of the amp’s valve circuitry.<br />
15<br />
9<br />
12<br />
14<br />
21<br />
9<br />
16<br />
9<br />
16<br />
10<br />
PROBLEMS AND SOLUTIONS