SE Plus-R · SEL Plus-R · SEM Plus-R - ELV

GBInstallation and electrical connection2.3. SELVE radio special featuresAll SELVE radio drives receive radio signals on 868.3 MHz radio frequency. All SELVEintronic transmitters can be taught into these drives. Up to 16 transmitters can betaught into one motor. Please adhere to the transmitter operating instructions.The range of the radio controllers is restricted by legal provisions for radio sets and bystructural conditions.You should ensure that you have perfect radio reception during planning, particularlyif the transmitter is in a different room than the radio drive.Ensure that you do not install the controller in the immediate vicinity of metal surfaces.Similarly, powerful local transmitting stations with an identical frequency may interferewith smooth operation of the system as well.3. Installation and electrical connectionWarning!Important! Risk of injury through an electric shock!Connection only when de-energised!Run the drive only after installation.3.1. Installation of the drive into a shaft1. Attach crown and coupling adapter to the motor and fasten them with thelocking device.2. Push the drive into the shaft in a positive-locking way. The drive must not besubject to any impacts. Crown and coupling adapters must not have any playinside the shaft.3. Where required, secure the drive axially, e.g. by screwing the shaft to the couplingadapter. Do not drill holes into the drive area!4. Attach the shaft with the drive and the shaft cap in the bearings. Do not bendthe motor cable and aerial and place them so that neither the aerial nor themotor cable cannot be damaged. Do not place the aerial parallel to the motorcable. The aerial must not be shortened or extended. To keep water from gettinginto the motor, place the motor line in a bend direction downwards, so that anywater can drip off.5. Attach the curtain to the shaft.26