SE Plus-R · SEL Plus-R · SEM Plus-R - ELV

GBSetting the end positions4.4.2. Manual setup-mode for SE Plus-R, SEL Plus-R and SES-R in operation: bottom position, top positionWhen the movement is interrupted once, the system is in manual setup-mode.In manual setup-mode, the lower end position must be set and stored first. Afterwards,the upper end position can be set and stored.Important!Only connect that radio drive to power that is to be programmed! You cannot programmore than one drive at the same time.Setting withtransmitterSetting withsettingswitchDrivemovement1. Connect to power.Only SEL Plus-Rand SES-R6 sec.or3 sec.6 sec.3 sec.2. For setting with transmitter: press the UPand DOWN buttons at the transmitter atthe same time. The transmitter is temporarilytaught into the drive.3. Only SEL Plus-R and SES-R: Press theSTOP button on your transmitter or theE button of the setting cable for 6 se -conds.4. Move the drive to the lower end positionwith the UP or DOWN button. Press theSTOP or E button for 3 seconds Thecorrect rotation direction assignment willbe carried out at the end of the endpo sition setting.or3 sec.3 sec.5. Move the drive to the designated upperend position and press the STOP orE button for 3 seconds.6. The end positions are now set and therotation direction assignment is correct.Perform a test run.PROG1 sec.PROG1 sec.7. For setting with transmitter: press thePROG button at the transmitter.When setting with setting cable: press theUP and DOWN buttons on the transmitterat the same time, and then thePROG button.8. The transmitter is now permanentlytaught-in.32