SE Plus-R · SEL Plus-R · SEM Plus-R - ELV

Functions in service modeGB8.4. Group separationA group is an assembly of several drives/receivers that can be controlled by one transmitter/channel.This transmitter is deleted after the end of the group separation. Duringgroup separation, each drive/receiver will only once move randomly for 3 secondswithin a period of time of approx. 2 minutes. Stopping the drive with any transmitterwill teach this transmitter into the respective drive.First press the STOP button and then the UP and DOWN buttons as well. Keep all threebuttons depressed for 9 seconds, in order to start the group separation (wait until thetransmitter control light flashes three times). The drive indicates activation of groupseparation by a short run. Then each drive will move randomly for 3 seconds within aperiod of about 2 minutes. Within the 3-second time slot, stop the movement of themotor using the STOP button on the transmitter to be programmed. Then the transmitteris taught in, and the drive has left the group separation mode.Fuse/Hirschmann plug3 sec. 3 sec. 3 sec.➧9 sec.➧Window 13 sec.Transmitter1Window 23 sec.Transmitter2Window 3✓3 sec.Transmitter3Every drive moves randomly only for3 seconds within about 2 minutes.The drive in question must bestopped by the selected trans mitterduring the movement.If the drives are still moving together, repeat the procedure for the drives affected.If you did not teach in a transmitter through the STOP button and no other transmitteris taught in, you may teach in this transmitter again by pressing the UP and DOWNbuttons at the same time and then pressing the PROG button.39