11.07.2015 Views

Bruciatori di gasolio Öl-Gebläsebrenner Brûleurs fioul Oil burners

Bruciatori di gasolio Öl-Gebläsebrenner Brûleurs fioul Oil burners

Bruciatori di gasolio Öl-Gebläsebrenner Brûleurs fioul Oil burners

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

4.5 FUEL HEATINGIn order to assure regular ignition and working also at low temperature the burner has an oil pre-heaterfitted in combustion head. The pre-heater starts when thermostats close.When the required temperature for ignition is reached the thermostat fitted on the nozzle holder starts theburner. The pre-heater remains energised during working and cuts out when burner shuts-down.4.6 BURNER START-UP CYCLEThermostatHeatingMotorIgnition transformerValveLow-flameHigh-flameLock-out lampLock-out due tofailure to shut-downNormalLock-out due tofailure to lightALock-out due tofailure to shut-down0–150s 3–9s 0–150s ~12s0–150s 3–9sB20–60s~12s5s~12sD5531ABLock out is in<strong>di</strong>cated by a lamp on the control box (3, fig. 1, page 1).In this case the burner will not reset because there is a serious fault.CALL THE SERVICE AGENTTHE AUTHORIZED SERVICE AGENT WILL FIRST OF ALL CHECK THE EFFICIENCY OF:■ Flame detector (7, fig. 1, page 1).■ Pump: interception valve (7), or pressure adjuster piston (5), see fig. 8, page 4.BURNER CAN BE RESET WITH A PROPER TOOL INSERTED INTO THE HOLE LOCATED AT THE BOTTOMOF THE CONTROL BOX.5. MAINTENANCEBurner requires a perio<strong>di</strong>c maintenance carried out by a qualified and authorized technicians.Maintenance is essential for the reliability of the burner, avoi<strong>di</strong>ng the excessive consumption of fuel andconsequent pollution.Before carrying out any cleaning or control always first switch off the electrical supply to theburner acting on the main switch of the system.THE BASIC CHECKS ARE:■ Check that there are not obstructions or dents in the supply or return oil pipes.■ Clean the filter in the oil suction line and in the pump.■ Check for correct fuel consumption.■ Replace the nozzle.■ Clean the combustion head in the fuel exit area, on the turbolating <strong>di</strong>sc.■ Leave the burner working without interruptions for 10 min. and set rightly all the components stated inthis manual. Then carry out a combustion check verifying:● Smoke temperature at the chimney; ● Content of CO2 (%); ● Content of CO (ppm);● Smoke value accor<strong>di</strong>ng to opacity smokes index accor<strong>di</strong>ng to Bacharach scale.23209 GB

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!