operator's manual wireless dosimetry system - Best Medical Canada

OPERATOR'S MANUAL FOR THE SYSTEM
4.3 TREATMENT INFORMATION (SCREEN 2)
Figure 4-5: Treatment Information Screen
When you have completed the Equipment Setup, you can then move to the next step by
simply clicking on the tab "Treatment Info". Treatment Information is input here, including
the target dose, as well as assigning the dosimeters to be used to the patient or phantom.
As the dosimeter locations are displayed both in a table as well as graphically, a
description of the location is entered in the Position column.
Once this information has been completed, it can be saved for use in future sessions
without having to re-input patient information or reassigning the dosimeters (see Section
4.3.3, for the use of templates).
ATTENTION
• You will NOT be able to read dose data if you do not select one or more
dosimeters. Select the dosimeters that you wish to read by clicking the MOSFET
Use column corresponding to the dosimeter(s) that you wish to use. A checkmark
will appear indicating which dosimeter(s) have been selected.
• When assigning dosimeters, ensure that you select the dosimeters that directly
correspond to the dosimeters you are actually using on the patient.
Page 30 of 62