operator's manual wireless dosimetry system - Best Medical Canada

OPERATOR'S MANUAL FOR THE SYSTEM
5.5 WIRELESS TRANSCEIVER
MOUNTING HOLES, 03.3x23 mm
5V DC INPUT
Figure 5-7: Wireless Transceiver
The transceiver is used to control the Reader and receive dose data wirelessly. It
has been configured so that it is dedicated to Best Medical Canada Ltd’s
mobileMOSFET Wireless Dosimetry System.
Before using the transceiver, you must:
• Mount the transceiver in the treatment room. For reliable communication, we
suggest that you place the transceiver in a location (on a wall) at a height of 2
meters/6.5 feet or higher from the floor, and without obstacles (i.e. brick or steel
reinforced walls) between the transceiver and the Reader. Do not place the
transceiver close to large metal objects.
• Provide power to the transceiver using the 5V DC Power Supply
• Connect the transceiver to your computer’s COM Port using the DTE-to-DTE
RS-232 cable
NOTE: THIS TRANSCEIVER IS INTENDED FOR SHORT-RANGE (10 METERS/30
FEET) COMMUNICATION ONLY. IF THE READER IS PLACED TOO FAR FROM
THE TRANSCEIVER, COMMUNICATION MAY NOT BE ESTABLISHED.
The wireless transceiver emits four different colors of light to indicate which mode it is in.
They are:
Green - The transmitter is idle.
Red - It is communicating with the PC.
Blue - It is communicating with the Reader.
Purple - It is attempting to communicate with the Reader.
Page 50 of 62
CABLE CONNECTOR