9362576b, Operating Manual Twin-DVR Sat Receiver ... - Kathrein

TVTV EPG and Timer
Programming a Recording
If no EPG data is available for
the channel you selected:
In the “Current” view select the
channel for which you want to
programme a recording and
press the red button. As
there is no EPG data, you must
enter the data (date, start, end)
manually. Use the arrow buttons
( ) and number
buttons to make your input.
Press to save your settings.
You can use the buttons to switch to the details on the next
programme in the selected view. Press to return to the previous
display, such as the programme list.
You can programme a recording from the various views of the
EPG (“Current”, “Program list”, “Highlights” and “Det.information”
[Details]) and from within their various submenus.
Programming is pre-configured for two SAT IF input signals. If you are
operating the receiver in Loop mode (“LNB 1 Loop out” output on
“LNB 2 in” input), this may cause problems when two programmes are
recorded at once (if both programmes are not transmitted on the same
transponder).
Use the arrow buttons ( ) to select the programme you
want and press the red button. The following display appears
(example):
35