9362576b, Operating Manual Twin-DVR Sat Receiver ... - Kathrein

Installation Menu
74
DiSEqC Setting
Tuner Select
The precondition for this setting is that you have not made any
changes in the DiSEqC (UFO) setup; refer to the “DiSEqC
UFO Setup” section.
When you are in the LNB Configuration menu (see above), press the
the or button and
buttons to move the coloured bar to the “HOTBIRD” item. Press
to confirm that you want to add a
satellite. The transponder data is now stored and a tick appears after
“HOTBIRD” to confirm the setting. You can now set the DiSEqC
signal. It is used to switch between the two aligned satellites. Press
to access the DiSEqC 1 setup.
Set #1 for ASTRA and #2 for HOTBIRD. Both positions are preprogrammed.
Press four times to exit the menu. This saves the set
value. If you make an incorrect setting, you will see the following
message:
Weak signal or no signal
With cascaded switches, a total of 16 satellite positions can be stored
under DiSEqC2. H/V and High/Low give a total of 256 possible
settings. These settings and the configuration of a system of this kind
should be left to a specialist.
Here you select whether both tuners (IF input) are connected to the
antenna system or only one of them. In the “Loop” setting, the
reception signal is looped through to the outputs, in order to make it
available for other Sat receivers.